The EtherChannel is configured with a speed of 1000 and duplex as full on both ends of channel group 1. What is the next step to configure the channel on switch A to respond to but not initiate LACP communication?
A.
interface range gigabitethernet0/0/0-15 channel-group 1 mode on
B.
interface range gigabitethernet0/0/0-15 channel-group 1 mode desirable
C.
interface port-channel 1 channel-group 1 mode auto
interface port-channel 1 channel-group 1 mode passive. Switching questions depend on MAC learning, VLAN membership, trunking, STP election, and EtherChannel behavior. Cisco CCNA 200-301 v1.1 includes this under Network Access, where the expected skill is selecting the feature that actually produces the requested network behavior. The wording normally gives the clue: protocol family, address scope, trunk state, route preference, security mode, API method, or controller role. Wrong answers misapply a Layer 2 rule or configure the wrong logical interface. In production, choosing the wrong option would typically cause failed client access, a broken route, insecure management, or an automation workflow that targets the wrong interface. The selected answer is the Cisco-consistent behavior for this item.
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit