Pass the Citrix CCA-AppDS 1Y0-241 Questions and answers with CertsForce

https://docs.citrix.com/en-us/citrix-adc/current-release/ssl/how-to-articles/end-to-end-encrypt.html

Correct Answer: A. Admin partitions that use dedicated VLANs

Short Explanation with reference: Admin partitions are a feature of Citrix ADC that allow administrators to create multiple logical partitions on a single physical appliance. Each partition is independent and isolated from the others, and has its own configuration, resources, and management. This enables administrators to delegate administration tasks to different departments or customers, while maintaining security and operational consistency1. Admin partitions can use dedicated VLANs to isolate the network traffic of each partition from the others2. A SNIP in each partition, and bind a VLAN for the department (option B) is also a valid way to isolate network traffic, but it does not provide configuration and management isolation. Policy-based routes for each department in the nsroot partition (option C) and dedicated routes in the admin partitions for each department (option D) are not relevant for isolating department-level administration, as they are used for routing traffic based on policies or routes3. Therefore, the correct answer is A. Admin partitions that use dedicated VLANs.

https://docs.citrix.com/en-us/citrix-adc/current-release/ssl/how-to-articles/create-and-use-ssl-certificates-on-a-citrix-adc-appliance.html

Correct Answer: B. Two-arm

Short Explanation with reference:

A two-arm deployment is a common scenario where the Citrix ADC appliance has two network interfaces, one connected to the DMZ network and the other connected to the internal network1. This allows the appliance to act as a gateway between the two networks and provide load balancing, security, and optimization features for the applications hosted on the internal servers2. A two-arm deployment also provides better isolation and protection for the internal network than a one-arm deployment, where the appliance has only one network interface connected to a switch or router that spans both networks3. A transparent mode is a packet forwarding mode that enables the appliance to act as a Layer 2 device and bridge packets that are not destined for it4. A forward proxy mode is a feature that enables the appliance to act as an intermediary between clients and servers on the internet, caching web content and applying policies. Neither of these modes are relevant for the scenario described in the question.

1: Citrix ADC at a Glance 2: Tech Paper: Best practices for NetScaler ADC Deployments 3: Configure a Citrix ADC BLX appliance with a network mode 4: Packet forwarding modes | NetScaler 14.1 : Configuring Forward Proxy | NetScaler 14.1

- Pol1 has a prio of 90 so it's evaluated first

-gotoPrioExpression NEXT means that it will evaluate next item in the policy list

- Pol2 has a prio of 100, so it"s avaluated after Pol1

https://docs.citrix.com/en-us/citrix-adc/current-release/content-switching/protecting-against-failure.html#configuring-a-redirection-url

“If a content switching virtual server is configured with both a backup virtual server and a redirect URL, the backup virtual server takes precedence over the redirect URL. A redirect URL is used when the primary and backup virtual servers are down.”

"Verify the URL and policy bindings. The client receives the 503 response when none of the policies you have configured is evaluated and no default load balancing virtual server is defined and bound to the content switching virtual server." https://docs.citrix.com/en-us/citrix-adc/current-release/content-switching/troubleshooting.html