Pass the Brocade Converged 170-010 Questions and answers with CertsForce

Viewing page 3 out of 3 pages
Viewing questions 21-30 out of questions
Questions # 21:

vyatta@vyatta:~$ show dhcp client leases

interface : eth1

last update : Wed Jun 19 00:06:00 GMT 2013

reason : FAIL

vyatta@vyatta:~$

Based on the output shown, which two statements are true? (Choose two.)

Options:

A.

Interface eth1 is configured to acquire an address through DHCP.


B.

Interface eth1 has failed.


C.

Interface eth1 is disconnected.


D.

Interface eth1 does not have an IP address.


Expert Solution
Questions # 22:

You want to capture all traffic traversing an Ethernet switch on your workstation for protocol monitoring.

What must you do?

Options:

A.

Connect your workstation to a VLAN trunk port on the switch.


B.

Place the card on your workstation into promiscuous mode.


C.

Connect your workstation to an analyzer port on the switch.


D.

Configure the switch to forward all traffic to your switch port.


Expert Solution
Questions # 23:

Which two steps are required to enable logging of NAT traffic? (Choose two.)

Options:

A.

Enable logging of the NAT rule.


B.

Enable logging of the NAT rulebase.


C.

Ensure there is sufficient disk space for potential logged information.


D.

Enable debug-level logging on the device.


Expert Solution
Questions # 24:

Which command line will display configured static routes only?

Options:

A.

show ip route static


B.

show route static


C.

show static route


D.

show ip route filter static


Expert Solution
Questions # 25:

Which two elements must you configure in your Brocade Vyatta vRouter to register your software license? (Choose two.)

Options:

A.

service assignment


B.

repository username/password


C.

license key


D.

entitlement key


Expert Solution
Viewing page 3 out of 3 pages
Viewing questions 21-30 out of questions