You are requested to design a network that requires a minimum of five subnets with a minimum of 16 hosts per subnet.
With the class C network of 200.101.192.0, which subnet mask would be used to fulfill these requirements?
What are two valid ways to represent the IPv6 address 2001:0000:0000:0200:002D:D0FF:FE48:4672? (Choose two.)
Which two statements about ICL links in Brocade Multi-Chassis Trunk (MCT) implementations are true? (Choose two.)
Which two results does the link-aggregate configure key
A client had ports 1/3/1 and 1/3/2 on the Brocade FCX go down because of errors being received from the upstream switch. The client repaired the upstream switch but the ports of the FCX are still down.
Referring to the command output shown above, what does the client need to do to bring up the links?
What happens to Ethernet frames that enter a switch with MAC learning disabled on all interfaces?
An identical route has been discovered by OSPF and RIP. By default, the OSPF route is chosen and added to the routing table. What should be done to allow the RIP route to be preferred?
What are two methods that a Brocade device can be configured for load sharing? (Choose two.)
You are implementing an OSPF network with five defined areas. You want to configure OSPF area route sharing to other specified OSPF areas.
Which router will you need to configure to share area routes with other area routes?
Which two Brocade products are recommended for core/aggregation use? (Choose two.)
