In Oracle Planning 2024’s Capital module, enabling Named Assets allows planning for specific, individually tracked assets (e.g., equipment, buildings) rather than generic asset categories. The two tasks you can perform when enabling Named Assets are:

A. Add the names of assets to plan at the detail level: Correct. When enabling Named Assets, you can specify the names of individual assets (e.g., “Truck A,” “Building 1”) to plan their costs, depreciation, and other details at a granular level.

B. Specify the likely number of tangible and intangible assets that you want to add in a planning cycle: Incorrect. While you estimate a maximum number of Named Assets during enablement, you don’t specify them by tangible/intangible categories—the distinction is managed later in asset planning, not at enablement.

C. Decrease the number of named assets after enabling Named Assets: Incorrect. Once Named Assets is enabled with a maximum number, you cannot decrease this limit directly; it requires reconfiguration or disabling/re-enabling the feature, which is not a standard task.

D. Increase the number of named assets after enabling Named Assets: Correct. After enablement, you can increase the maximum number of Named Assets (e.g., from 100 to 150) via the Configure card, allowing more assets to be added as needed.

The Oracle documentation confirms that A (adding asset names) and D (increasing the count post-enablement) are supported tasks for Named Assets, making them the correct answers.