To determine proper policy ordering for Netskope Real-time Protection policies, you need to follow these two statements: B. You do not need to create an “allow all” Web Access policy at the bottom. D. You must place high-risk block policies at the top. These statements are based on the best practices for policy ordering recommended by Netskope3. An “allow all” Web Access policy at the bottom is not necessary because any traffic that does not match any policy will be allowed by default. However, you can create a “monitor all” Web Access policy at the bottom if you want to log all the traffic that is not matched by any other policy4. High-risk block policies at the top are important because they prevent any traffic that poses a serious threat or violates a critical compliance standard from reaching its destination. These policies should have higher priority than other policies that may allow or modify the traffic5. Therefore, options B and D are correct and the other options are incorrect. References: Real-time Protection Policies - Netskope Knowledge Portal, Create a Real-time Protection Policy for Web Categories - Netskope Knowledge Portal, Best Practices: Real-time Protection Policies (1 of 2) - Netskope