The expected answer is eight narrow beams because the described configuration permits up to eight Synchronization Signal/PBCH Blocks (SSBs) within an applicable SSB burst set.
In 5G NR, beam sweeping enables the gNodeB to transmit synchronization information in different spatial directions, allowing UEs to identify suitable beams during cell search and initial access.
An SSB contains the Primary Synchronization Signal (PSS), Secondary Synchronization Signal (SSS), Physical Broadcast Channel (PBCH), and associated demodulation reference signals.
SSB pattern Case C uses 30 kHz subcarrier spacing and specifies candidate SSB transmission locations within the applicable half-frame.
For a configuration supporting a maximum of eight SSBs, the network can associate eight transmitted SSBs with eight distinct beam directions.
The specified 4:1 TDD slot configuration influences the available downlink transmission occasions, while the SSB pattern defines the candidate synchronization-block positions.
When all eight candidate SSB positions are configured for transmission, the gNodeB can sweep eight narrow beams during the SSB burst set.
However, the maximum supported SSB count and the number actually transmitted are not necessarily identical. The network can configure a smaller active subset.
Therefore, eight is the intended answer under the assumption that all eight SSB positions are enabled.
Official Reference: 3GPP TS 38.213, Section 4.1, Cell Search and SS/PBCH Block Candidate Positions ; TS 38.211, Section 7.4.3, SS/PBCH Block Structure .
Technical warning / qualification: The question specifies a maximum of eight SSBs but does not explicitly state that all eight are transmitted. The correct choice is A under the intended full-beam configuration.
Submit