WLAN planning for restrooms requires particular attention to construction materials, wall attenuation, indoor coverage continuity, and practical AP installation locations.
Although adjacent rooms can sometimes be covered by a shared access point, restroom environments present additional RF propagation challenges. Restroom partition walls are commonly constructed using brick, concrete, ceramic tiles, and other materials that may significantly attenuate wireless signals.
Huawei's planning guidance specifically states that walls between adjacent restrooms are generally thick and that relying on wireless signals to penetrate these walls is not recommended.
Consequently, placing a single AP between men's and women's restrooms may produce inadequate coverage in one or both areas. Users could experience weak received signal strength, reduced physical-layer rates, retransmissions, or connectivity instability.
Huawei therefore recommends deploying an independent indoor AP in each restroom.
The recommended AP configuration uses omnidirectional antennas with ceiling-mounted installation, allowing radio coverage to be distributed within the individual restroom.
Where architectural appearance is important, the installation design should incorporate suitable aesthetic measures without compromising wireless performance.
This recommendation differs from planning for lightly partitioned office areas, where a shared AP may provide sufficient coverage across multiple rooms.
Therefore, the statement is FALSE.
Training Material reference: WLAN Planning Scenarios → WLAN Planning and Design for Typical Scenarios → WLAN Deployment Solution for Restrooms, PDF p. 544.
────────────────────────────────────────────────────────
Submit