The correct answer is C. The existing 5406R configuration uses an LACP trunk, with VLANs 100, 200, and 300 tagged and VLAN 50 untagged. The equivalent HPE Aruba Networking AOS-CX configuration is to create a LAG, enable LACP using lacp mode active, allow the tagged VLANs on the trunk, and configure VLAN 50 as the native VLAN. In AOS-CX, the vlan trunk native < VLAN-ID > command assigns the native VLAN to the trunk or LAG interface. Native VLAN traffic is untagged unless native VLAN tagging is specifically configured. HPE Aruba documentation also shows the command syntax for assigning native VLANs to LAG interfaces and the use of vlan trunk allowed for the VLANs carried on the trunk. Option A and option B are incorrect because lacp mode enable and the shown native VLAN syntax are not the correct CX syntax. Option D is less correct because VLAN 50 is the native untagged VLAN and does not need to be included with the tagged VLAN list. The correct CX equivalent is therefore LACP active, allowed VLANs 100, 200, and 300, and native VLAN 50.