Pre-Summer Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: force70

  1. Home
  2. Discussions
  3. Cisco
  4. CCDE v3.0
  5. 400-007 Discussions
  6. 400-007 Exam Topic 14 Question 132 Discussion

Cisco Certified Design Expert (CCDE v3.1) 400-007 Question # 132 Topic 14 Discussion

 Cisco Discussions      Browse All Questions      Go to Exam Detail      Get Premium Access
 Previous
Next  

Cisco Certified Design Expert (CCDE v3.1) 400-007 Question # 132 Topic 14 Discussion

400-007 Exam Topic 14 Question 132 Discussion:
Question #: 132
Topic #: 14

Two routers R1 and R2 are directly connected through an Ethernet link. Both routers are running OSPF over the Ethernet link and OSPF has been registered with BFD. R1 has been set up to transmit BFD at a 50 ms interval, but R2 can receive only at a 100 ms rate due to platform limitations. What does this mean?
A.

After the initial timer exchange, R2 sets its transmission rate to the R1 Desired Min TX interval

B.

After the initial timer exchange, R1 sets its transmission rate to the R2 Required Min RX interval

C.

Timers renegotiate indefinitely, so the timer exchange phase never converges

D.

R2 sets the P-bit on all BFD control packets until R2 sends a packet with the F-bit set

Get Premium 400-007 Questions
Actual exam question for Cisco 400-007 exam by Eris88203 at May 31, 2026, 8:36:08 PM

Contribute your Thoughts:


Chosen Answer:
This is a voting comment (?). It is better to Upvote an existing comment if you don't have anything to add.

Submit
 Previous
Next