A customer implements Cisco ACI Multi-Site with default MTU settings between two sites. Which configuration should be applied on the interface Eth1/10 on the ISN-1 device?
In a Cisco ACI Multi-Site setup, it’s important to configure the ISN interfaces to handle the encapsulation overhead introduced by the multi-site architecture. Option C is typically the correct choice because it includes:
A subinterface with a specific VLAN ID for traffic segregation.
An increased MTU size to accommodate the extra bytes added by encapsulation.
The correct VRF for inter-site communication.
OSPF configuration for dynamic routing between sites.
References: = Implementing Cisco Application Centric Infrastructure Official Cert Guide
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit