You have used the "set inactivity-timeout 120" command to prevent the session to be disconnected after 10 minutes of inactivity. However, the Web session is being disconnected after 10 minutes. Why?
A.
The idle timeout for the web session is specified with the "set web session-timeout" command.
B.
The number specified is the amount of the idle timeout in seconds rather than in minutes. So you have to use the command "set inactivity-timeout 600" instead.
C.
Probably, you have forgotten to make sure that nobody is accessing the management server via the SmartConsole which locks the management database.
D.
The number of minutes is correct. Probably, you have forgotten to save this setting with the "save config" command.
The reason why the web session is being disconnected after 10 minutes is that the idle timeout for the web session is specified with the “set web session-timeout” command, not the “set inactivity-timeout” command. The “set inactivity-timeout” command only affects the CLI session, not the web session. To prevent the web session from being disconnected after 10 minutes of inactivity, you need to use the “set web session-timeout” command with a higher value than 10 minutes. References: [Check Point Security Expert R81 Administration Guide], page 77.
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit