The correct command to observe the Sync traffic in a VRRP environment is fw monitor –e “accept dst=224.0.0.18;”. This command captures the packets that have the destination IP address of 224.0.0.18, which is the multicast address used by VRRP for synchronization. The other commands are either not valid or not specific to VRRP Sync traffic. References: [Check Point R81 ClusterXL Administration Guide], Check Point R81 Performance Tuning Administration Guide
Contribute your Thoughts:
Chosen Answer:
This is a voting comment (?). You can switch to a simple comment. It is better to Upvote an existing comment if you don't have anything to add.
Submit